Focus on heavy equipment
The three-pass sand dryer has high working efficiency and does not have a lot of debris, so there is no need to clean up a large area. So how should the equipment be properly cleaned after being used for a long time? The sand dryer that works for a long time should be cleaned regularly, so as to more effectively ensure the long-term operation of the sand dryer and high efficiency.
The cleaning of the dryer can be summarized into three points in a simple way:
First, the cleaning of the inner liner of the sand dryer. The role of the internal lining board in the structure of the sand dryer is very important. The lining board should be inspected and cleaned first to check if there is any damage and perform detailed cleaning to ensure that the equipment is in good condition.
Second, the cleaning of the retaining ring and the feed pipe. The sand dryer may have some residues on it during the working process. If it is not cleaned for a long time, it may affect the ventilation effect and not work normally, so the residues should be cleaned regularly.
Third, clean up the flue opening and the inside of the dryer. If the sand dryer works for a long time, a certain amount of dust will accumulate in the flue chamber, which will affect the smoothness of the material.
In addition, inside the barrel, the material moisture is too high, or the material is fed too much, and the material adheres to the barrel. A simple cleaning can be done inside the cylinder to ensure the smoothness of the material.
At the same time, please pay attention: after finishing these tasks, the staff should withdraw the tools used, so as not to affect the next work or stay inside the cylinder and cause safety impact.
The above is about the matters needing attention when cleaning the sand dryer. The above is about the matters needing attention when cleaning the sand dryer. The three-pass sand dryer produced by Zhengzhou Jiutian Machinery is highly efficient. After you purchase, you need to train the technicians, and timely maintenance and repair to ensure the service life of the sand dryer. If you want to know more information, please contact us at any time.
Limestone dryer can be used to dry limestone, clay, slag, carbide slag, water slag and other materials. The material enters the dryer through the conveying equipment, and the heat carrier contacts the material in reverse. The water in the material is evap
ETP sludge is difficult to use industrially due to its high moisture content and low calorific value. It also contains high concentrations of chemicals and heavy metals, posing a significant risk of environmental pollution. In response to the current stat
Aggregate drying requires an aggregate dryer, the most common of which is a drum dryer, which consists of a drying drum, a heat source device, a conveying device, a screener, etc. After the aggregate enters the drying drum from the feed end, the aggregate
As an expert in rotary dryers, Zhengzhou Jiutian has carried out technical upgrades and innovative designs for gypsum dryers based on the characteristics of gypsum: multi-stage hot air circulation and waste heat recovery technology are used to better redu