Focus on heavy equipment
The river sand dryer adopts a new type of three-pass dryer, which has high drying efficiency and low price. So, how to make the river sand dryer achieve the ideal drying effect?
1. Control the initial moisture of the sand
Materials with particularly high water content should be properly dehydrated before drying, and then dried after meeting the feeding standards of the dryer. This can not only improve the processing efficiency of materials, but also avoid increasing the loss of machines.
2. Boot preparation
Before the load test machine, test run the attached equipment first. The dryer needs a preheating process, and it cannot be burned on a high fire, so as to avoid local overheating and uneven thermal expansion to damage the equipment. While preheating, turn on the dryer to rotate, so as not to avoid uneven heat and cause the cylinder to bend.
3. Stable feeding
The drying of the material in the sand dryer depends on the full contact between the material and the heat carrier, and the drying is realized by means of heat exchange. Therefore, it is particularly important to grasp the amount of material and the amount of fuel in the furnace during work. The raw material or the burning fuel must be fed in smoothly and evenly, and the feeding ratio cannot be changed suddenly.
4. Stop and turn off
For machine operation technology, please turn the temperature regulator knob to the 0 degree position to reduce improper start-up and prolong the life of the solenoid valve.
5. Choose the equipment that suits you
The choice of river sand dryer needs to be selected according to its own actual situation, so as to bring higher economic benefits to users and make sand materials better dried.
Zhengzhou Jiutian is river sand dryer manufacturer, if you have any questions, please contact us.
Silica sand if mainly composed of SiO2, which has good wear resistance, fire resistance, and insulation properties. It is widely used in glass, casting, ceramics, refractory materials, metallurgy and other industries. However, natural silica sand contains
Nickel ore is an important raw material for producing batteries and stainless steel. However, with the resources of sulfide nickel ore decreasing, currently the nickel ore primarily comes from laterite nickel ore. Laterite nickel ore has a high moisture c
The rotary sludge drying system is specifically designed for sludge with high moisture content, high viscosity, and low calorific value, it is usually used in sludge treatment in municipal, dyeing, and papermaking industries. After dewatering by a filter
Aggregates are used for skeleton and filling in concrete and mortar, including fine aggregates with a diameter of 0.16-5mm and coarse aggregates with a diameter bigger than 5mm. The sand, gravel, and crushed stone commonly found in our daily lives can all